HMS Fearless

[Walter2]

I will soon begin work on the HMS Fearless model. The original is 3ft long, but I have scaled it down to 75%. Construction report attached again.

 

[zathros]

I've only seem this model built once before. It's a great looking ship. Great choice.

This one is huge, some skinny person might be able to get inside!!

 

[mijob]

This a very cool looking model. Im looking forward to follow this thread.

 

[Rhaven Blaack]

This is a rather interesting looking ship.
Please forgive me for being thick. However, I am not at all familiar with its design or from what SCI-FI it is derived.

 

[Walter2]

The ship originates from David Weber's book series “Honor Harrington.”

 

[zathros]

Story wise, it's not that old of a story. I read a synopsis of it, it was very interesting. It would make a great movie franchise.

 

[Rhaven Blaack]

The ship originates from David Weber's book series “Honor Harrington.”

Thank you for the clarification. I will look it up.

 

[Walter2]

We'll start with these parts. The model is quite complex because the adhesive tabs are missing (you have to attach them yourself) and because of the reinforcements made of 0,039 inch (1mm) and 0.01inch (0,5mm) cardboard. It's likely to be a time-consuming project.

 

[zathros]

No tabs eh?I like it even more!!

 

[Walter2]

I'd say it makes things more interesting, and the “strokes” end up being more precise and beautiful.

 

[Walter2]

The first parts are done—boat bays, lower block, sensor mount, sensor wings, floor grilles, and sensor capsules—all reinforced with cardboard and featuring added glue tabs. Because of this, I realize the model will take longer to complete, but it’s fun.

 

[mijob]

Great start and nice cuts.

 

[Walter2]

The next small parts. I'm saving the bridge for last—it's very complicated; I've started and scrapped it three times.

 

[Walter2]

Middle section—and always make sure to reinforce it...

 

[zathros]

Deceivingly, not a simple model!

 

[Walter2]

indeed

 

[Walter2]

The middle section is done. The holes in the end pieces are meant for securing, but they could be closed up again.

 

[Walter2]

Cylinders and coils

 

[mijob]

Great progress and a lot of parts to assemble.