Banana PC jr. 6000
- Thread starter DJPinter
- Start date
Case Back
Side Panels
After your fingers have recovered from cutting the ventilation slots on B.3.4, B.3.5, B.2.3 and B.2.4 glue, B.2.3 on top of B.3.5 and B.2.4 on top of B.3.4. align all edges. Make sure that the vents lineup. Sand down any misalignment.
Next glue the B.2.3-B.3.5 assembly onto B.4.1, and B.2.4-B.3.4 on to B.4.4. Align the parts as indicated by the red arrows
The pattern and the protective film can be removed from the back of each assembly.
Glue B.0.9 on to B.1.10 and B.0.10 on to B.1.11. Align all edges and make sure the vents line up. Sand down any misalignment.
If using PVC board, remove the pattern and film from B.4.5 and B.4.2. Securely tape the back of the B.2.3 assembly to B.4.5. Do the same with the back of the B.2.4 assembly and B.4.2.
Flip the parts over and glue the B.0.10 assembly to B.4.5-B.2.4 and B.0.9 assembly to B.4.2-B.2.3. Align the parts as indicated by the red arrows. Make sure that the vents lineup. Sand down any misalignment.
DO NOT trim any overhanging paper. Set each panel aside.
Last edited:
Case Back
Top Panel
Remove the ventilation grills from B.3.3 if you don’t want hand cramps from cutting 2mm slots forever.If you used PVC boards, remove the pattern and film from B.4.3. If not, leave the pattern on. Flip B.4.3 so that had/has the pattern is facing down. Glue B.3.3 to B.4.3 aligning the parts where the arrows point.
Last edited: