Raging Bulls!
- Thread starter Cybergrinder
- Start date
Take 2. I'm happier with the feel and overall shape so far, here's the side pods/engine cover and the base that they attach to.
- Apr 5, 2013
- 14,544
- 11,247
I'd make good use of the grid on your cutting pad to make everything square and plumb.
Here we go, the two halves joined and to the base. Next up is the tail light section, which I have realised is also a former 
And here is the tail light section, minus suspension you note
Here's the tail light unit installed in the body and suspension attached
Again, Great work on this. The laser printed parts were more glossy, but these are beautiful, and they sell aqueous lacquer clear coats.
- Apr 5, 2013
- 14,544
- 11,247
Moving on to the front of the car, here we go with the underside not yet attached. I've still got out figure out the exact fitting of the aero parts.
