Took a break from building this weekend to paint up a couple of 3D printed busts. Both were supportless models printed at .05 mm on my modified Lulzbot Taz 5 with Matter Hackers Build PLA. Primed, and painted with Army Painter Speed Paints and then regular acrylics.
First off is the supportless Elf Archer I found on Thingiverse:
View attachment 215622View attachment 215623
Next is the supportless Mandalorian I found, sadly, I don't have a link for this one... I tried searching again, and it's lost in the THOUSANDS lying about there!
First off is the supportless Elf Archer I found on Thingiverse:
View attachment 215622View attachment 215623Next is the supportless Mandalorian I found, sadly, I don't have a link for this one... I tried searching again, and it's lost in the THOUSANDS lying about there!
