Search results

You are most welcome sir

My skills have improved quite a bit in the years since I built this. As I remember ... the sensor pod on top came from a file called Rubicon Final. I think that it was from Paragon. I did have to re-scale it to fit.

I built this years ago when Pdmccool first did the repaint, but you asked for some shots of it so here it is... hope it helps

The "Mystery" parts are an outside "brace/conduit" that attaches to the body of the runabout between the cabin and the pylons.

This looks to be the pdmccool repaint of Ninjatoes' Danube class runabout. If it is... then unfortunately instructions were never made. But if you have trouble, just ask, someone is bound to know, or can help you figure it out. I have only built this once, years ago, when pdmccool first did his...

Update: I got a little more done. I did a section of track all the road wheels and started on one of the trucks. It has taken a while, my big hands make it hard sometimes to make and maneuver small parts.

Update: I ran into some problems with the build and parts that required me to make some alterations. First... the base was 3 pieces, and I installed the rear one backwards (instruction shows the hole is in the center, but on the part it is closer to the end). Second... the body formers are in...

I've used one for about 10 years..... I like it better then the original handles. Even if you don't put your finger through the hole.... it's still easier to hold on to.

I purchased this model back before Thanksgiving and decided that now was as good of time as any to start it. I have never built a train before, so I don't know what to expect. I also purchased the F7B unit as well as the PineGrove sleeper car. I don't know if I will build them all at once or...

Thank you everyone for the kind words and support, I hope you enjoyed this build as much as I did.

Finito: Installed the windshield, headlights, windshield supports, parking break leaver, outside lanterns, and control peddles.

Thank you AC

Update: I did not like how the hood was fitting.... so I reprinted it. Because I had changed print cartridges ..... the green was a couple of shades off.... so I had to reprint most of the green parts. Added the body and finders and running boards. I modded the back doors so that you can see...

Glad to know that you are doing better RB. Praying for a speedy recovery for you.

Glad to see that you were not washed away in the tsunami out there

If I'm not mistaken..... I think its supposed to slide forward

Next Update: current state of the model. Seat and wheels installed.

Next Update: I've had these photos on my phone for a few days..... I need to redo the hood because as you can see... it doesn't fit properly.

Thank you for the information DC... I didn't know that

Update: I got the engine and firewall and the floor installed.