Recent content by DJPinter

I'd take a better modeler than me to get it into a museum.

Case Back Case Assembly Five parts make up the case back. PartSub Parts Case Back - BackB.0.1, B.0.11, B.3.1, B.1.1, B.2.1, B.0.12, B.0.13, B.4.7 Case Back - BottomB.0.8, B.4.6 Case Back - Left SideB.0.9, B.1.10, B.2.3, B.3.5, B.4.1, B.4.2 Case Back - Right SideB.0.10, B.1.11, B.2.4...

Case Back Top Panel Remove the ventilation slots from B.3.3 if you don’t want hand cramps from cutting 2mm slots forever. If you used PVC boards, remove the pattern and film from B.4.3. If not, leave the pattern on. Flip B.4.3 so that had/has the pattern is facing down. Glue B.3.3 to B.4.3...

Case Back Side Panels Each finished side panel's exterior layers will be larger than the bulkhead on the top by 3.8 mm. The bottom by 3.4 mm. After your fingers have recovered from cutting the ventilation slots on B.3.4, B.3.5, B.2.3 and B.2.4 glue, B.2.3 on top of B.3.5 and B.2.4 on top of...

Case Back Bottom Panel B.0.8 for Apple and Veidt. B.0.8 for Banana Glue B.0.8 onto B.4.6 aligning all edges. You’ll have to cut the slots for the legs wider than is indicated. The pattern has the slots at 1 mm. They need to be 3.61 mm (1/8”). Test fit with the Banana legs. Set the Bottom...

Case Back Back Panel Laminate the case back part (B.4.7) to the cardboard or PVC. If you’re building the Macintosh use page 18.If not use page 17. The finished part’s exterior layers will be larger than the bulkhead on the right, bottom and left by 3.4 mm. If you’re using cardboard...

Since I'm using 1/8" PVC board for the Bulkhead pieces (instead of corrugated cardboard) I made the executive decision to use the PVC board for the Banana Base support structure. That trimmed the page count from 85 to 81 and part count from 183 to 140. The Banana Base part layout diagram has...

There are 5 pdf files, one with 3 variants, for a total of 183 parts. As before, the part layout pics are just an overview. I’ll continue writing entries to this thread as I’m building the model. I’ll upload the pdf files along with an assembly guide when I’m done.

This is the absolute LAST time I post the part layouts. Banana Base.pdf Bulkhead.pdf Exterior (Banana/Apple/Veidt).pdf Interior.pdf Light Kit.pdf

Powerup 4.0 Paper Airplane Review: Level up your hobby plane

Paper plane launcher

Thanks, but that’s not mine. Hell, I still have completed my Banana PC jr yet!

From Facebook: