Search results

:laughrolling:i am delighted - thank you for life :bowdown:

That's right, a lot of creeping would be possible in the cockpit alone. I've already thought about doing something with fine wires for the technology. let's see. The Viper is on my to-do list... Unfortunately it is no longer available from UHU2, so I'll have to see where I can get it. Or the...

good idea :BRAVO:

Interior part 2 (almost finished)... The next parts are the lower engines with the rear shelves for the landing legs.

Motor finished top left. The next step is to continue building the interior of the main body...

Engine top right - part 2 - rear wing end - mount for laser cannons. I accidentally deleted pictures of the assembly of the rear of the engine, but it was nothing special, just a few cones glued together. I'll add them to the second engine, they're all the same anyway, at least most of them...

Engine top right - Part 1.

Cockpit and main body rear end (not yet fitted).

Sensor parts - Sensor computer parts - Navi computer. Next up is the cockpit. I'm still thinking about the best way to make the transparent "foil glazing" for the cockpit hood (double hood and glue foil in between? Let's see...).

I only realized today that you have the Intercepter in the works, or rather had it, I've been lurking around it for a long time. Now I can see what a challenge the model is. Maybe I'll go over it sometime. Anyway, my very highest praise for your work and your great photos!

Interior parts technology...

Part 3 - Frames and wing mounting frame. It was a little fiddly. The black frame is inserted and glued from behind, work carefully and pay attention to the center. Test-fit the wing.

Part 2 - the "frames":

One more tip - only roll the two small rolls with the green strips (motor on the open wing), do NOT glue them, then slide them into the other three parts and only then glue the whole thing together, otherwise there will be problems with the small holes. Unfortunately I discovered the trick too...

lower wing also finished, all to be assembled in the same way. We continue with the main body.

Upper wings finished. The next step is to finish the two lower wings.

Upper right wing finished with open technology.

Internal reinforcement finally finished. The next step is to assemble the upper right wing with the inner parts.

The base chassis is finished. After a long back and forth "what-how-where" I managed it. The only problem was that two changes were made to the "production plan" (for better stiffening), but these were only shown later (see pictures with the black parts and the frame).

Linkage for the wings