Search results

The details are great. But your skills rule...

Yep, this going to be interesting

In reality, the threads on the tire were quite shallow since this is a on road vehicle, I'd say around 1 cm deep. In scale, we're talking about 0.3 mm, which very close to the thickness of the 160 g/m2 paper (0.22mm) It means I could probably reprint the thread and cut out the thread pads and...

Zathros and Gandolf50 Thanks, I need to think about this...

Great job!

Hello all One more small update, this time the front seats.

Although I don't speak French, I understood everything Thank you, have fun with the models!

24 parts just for seat... Oh my...

Hello all After a break I had to take because of some unexpected things happened, I continued with this model. This time i started the crew compartment. Not too many things were done, only the floor, seat bases and rear power outtake tunnel guard. Next time - seats an more stuff...

Nice looking model. Could you please consider painting the edges of paper, including bends? This will add alot

Piece by piece... Great.

That's crazy. Snake, I think you should conduct a master class on cutting and assembling. But I have a philosophical question. Assuming there are 500 prints of this model ( if I am not wrong, 500 is the minimum amount for offset print), how many models will be built with such level of details...

Hello all! Today is my country's birthday, we all celebrate the Independence Day. So, Happy Independence Day, Israel. This also means that I had some time to build. First, I have some update on wheel nuts. I found that the smallest hex key in my set is 1.5 mm in max width, very close to 1.4...

Beautiful!

That is an interesting idea. Will check this.

Great job!

Hello all I tried to find a way of making the nuts for the wheels. I have in my toolbox a screwdriver with changing torx heads. The T4 size is the exact size of the nuts in-scale. Firtsly, I tried to make a punch using the syringe needle. I cut the angled tip off, and then I pushed the Torx...

Thanks Zathros for your advice I am almost sure we don't have this liquid tape product. The most common thread pattern is shown in the attached picture. The grid on the cutting mat is 1x1 cm (around 0.4 inch). The pattern has many small rhomb-shaped items. Unless I find some creative way to...

Hello all. Continue with the wheels. Oh, boy... That took me a lot of time. Each wheel is made from: 2 Tire side bases from cereals box 2 tire sides 1 tire thread ( the part that actually touches the ground) 1 tire bottom 1 rim (a parer ring 2 mm wide ) 1 rim cone 2 rim center pieces for...

Oh, boy.... That's unbelieveable. Great detailing