Search results

Also the wide must be control.

Then, I still control, whether is same the height of cross-ribs and long-ribs All possible would distinguish now must remove becomes

Hello friends, After few days force-pause reports me with together already stuck Frame scaffolding for underwater-crooked, that I put after the assembly on a straight surface and incriminate evenly with a few heavy books, again. That lasted 2 days Now, the whole construction is quite drily...

Below in the picture, I have signed which edges of frames we must change Cheers! Christoph

All frames have just edges what optimally for middle part of the trunk is. Nevertheless, in front and behind the trunk has other form What signifies that him carve run changes and across frame must have his contact surface no more legal to corner but as well as the edge course points.

Hello friends, After him when all parts for frame scaffolding I have prepared with this wise one, I do the first adaptation. Especially importantly is control on account of all "intersections" at the identical height are, on account of frame width corresponds to the trunk width. Now all...

With this wise one the round edge should be also also dragged. Very importantly the fact that with one may drag not the part too fast against the paper press (simply quite lightly push and always in of a direction) Greeting Christoph

This posture is of course a wrong because the contact surface of frames reduces

With trail I hold the part possibly thus with the sandpaper surface 90 degrees corner comes into being. As well as on the photo below. The sandpaper must lie on a just surface

Have not thought that I create still today this. After as me has cut out all frames, catch I all cut edges with sandpaper (K 400) trail

Here the small parts it has already cut out With the best greetings Christoph

The complete frame scaffolding exists of 25 across frames. The frames must be separated on cutting out, as well as on the photo below. (Underwater part)

Then the main deck was in it. Complete main deck exists of three parts. One must cut out of the middle part first them all parts for the airplane and then stick on 0.5 mm cardboard

On the long frames (4 pieces) an additional strengthening must still have stuck on on the edge for side armour plating.

Hello friends, You do not think that I a lounger am I might point what is already ready and what I must still do. Thus: When the first parts I have cut out were the long frames They should be strengthened with 1 mm cardboard as well as all parts by frame scaffolding

Hello friends, Today I have stuck on all frames on 1 mm and all main deck parts on 0.5 mm cardboard. Tomorrow all that cuts out. Then I get thick fingers again :cry: Greeting Christoph

Hello DN, The problem with the pictures has already repaired Ron. Now everything is OK Thanks for your auxiliary readiness!! With the best greetings Christoph

Hello Jim, I have tried everything. Form accepts no photos of me. Always the identical mistake. The problem also has Wilfried and other colleagues. It must be something with the forum. Can somebody check this? Greeting Christoph

Thanks friends! I have not earned so much praise and acknowledgment words. I am glad to being here and with you experiences exchange I wish all my forum colleagues A good slide the new year in 2005 With the best greetings Christoph

Hello Ron, I have checked everything. I the pictures do not publish here on forum can does not lie with my computer but is that a mistake with the forum. The forum accepts no pictures of me. Greeting Christoph