Recent content by Boris

Hello all everybody. Happy Passover to the members of the Jewish community, Happy Easter to the Catholics. I am back to my build of the MiG-21-F13. Last time I stopped at the nose pieces. I had to reprint and rebuild everything I built up until now since my three-legged dog stumbled and...

Please note, there are camo versions, one for 161 and another for 166 squadron

Boris submitted a new resource: Elbit Hermes 450 (Zik) in 1:33 scale - Hermes 450, RPAV, UAV Read more about this resource...

Hello all. One more update. This time the nose section. Unfortunately, these segments are almost not shown in the instructions. The front segment is closed with a glue tab at its front and the landing gear well should act as a positioner and a glue tab and a spacer for landing gear well edges to...

Thanks!!!

Thank you all, more updates soon

Nice joints, especially for such small parts

Hello all Even biggest of works is done in small steps. So a small update. I finished with a set of wiring or tubing behind the ejection seat, I used a copper wire 0.3mm in diameter, bent as described. Then I started with one of the most iconic parts of this plane - the inlet cone or the inlet...

Looks great, clean gluing lines

Impressive!!!

Hello all One small update. I finished with main landing gear housing structure, nothing serious here. Only two things made me scratch my head. The markings are slightly incorrect, left side sould go to the right. Also, vertical parts i.e. the ribs should have their black contour line removed to...

Well, it doesn't really matter if it was a good or a bad plane. It has its place in history of aviation, and quite a respectful one, being the most produced jet fighter in the world. And it has a nostalgic value for me, since the MiG21 was the first jet fighter I saw up close. And it has an...

Thanks all, actually I had to use a magnifying glass to work on the belts. BTW, it seems the lower belts are a bit too long. Nevermind, it will be like that.

Thanks!!!

Hello all Last time I began with ejection seat, this time I finished it. Very good parts fit, pretty close to real thing, great instructions, not too many overcomplicated things here. Nothing too difficult here. But I understood that the seat should have been made only at the time of canopy...